HPE Compaq StorageWorks SSL2000 Series Maintenance And Service Manual page 143

C-42 Compaq StorageWorks SSL2000 Series Library Maintenance and Service Guide
Drive 1 Bus ID: Lets you set the SCSI addresses of the drives. The designators Drive 1 through Drive 1 Bus ID: Drive 1 Bus ID: Drive 1 Bus ID:
Drive n refer to the second through n th drives, counting from the top unit in the Library system.
Vendor ID: Lets you specify the response of the Library's robotics to the SCSI INQUIRY Vendor ID: Vendor ID: Vendor ID:
command in the Vendor ID field. The default is Compaq.
Product ID: Lets you specify the response of the Library's robotics to the SCSI INQUIRY Product ID:
Product ID: Product ID:
command in the Product ID fields (Compaq SSL2000 Series) <Vendor unique>. The default is
SSL2000.
Negotiation Mode: Negotiation Mode: Lets you enable initiate synchronous negotiation. Initiate synchronous Negotiation Mode: Negotiation Mode:
negotiation, if set, allows the Library to initiate SCSI synchronous negotiation with the host (the
default is No). The Library always responds to host-initiated synchronous negotiation.
Transfer Rate: Transfer Rate: Lets you set the data transfer rate to 10 MB/s, 5 MB/s or asynchronous. The Transfer Rate: Transfer Rate:
default is 10 MB/s.
Mode Page 1F Length: Mode Page 1F Length: Lets you choose between two lengths of the mode sense/select device Mode Page 1F Length: Mode Page 1F Length:
capabilities page (SCSI page 1Fh), which are short (14 bytes) and long (18 bytes), to
accommodate different SCSI device implementations of this page. The default is Short.
Initialize Element Status: Lets you specify the unit's response to the SCSI INITIALIZE Initialize Element Status:
Initialize Element Status: Initialize Element Status:
ELEMENT STATUS command. The possible settings are No Inventory, Force Inventory, and
Force Label Scan. The default is No Inventory.
Unit Attn Report: Lets you select reporting of All or only One unit attention conditions. If set to Unit Attn Report:
Unit Attn Report: Unit Attn Report:
All, the unit reports all unit attention conditions in sequence; if set to One, the unit reports only
the highest priority condition. The default is All.
SCSI Mode: Defines the loader as SCSI-2 or SCSI-3. The default is SCSI-2. SCSI Mode SCSI Mode SCSI Mode
Post Recv'd Error: Enables reporting of TapeAlert informational exception conditions with a Post Recv'd Error Post Recv'd Error Post Recv'd Error
Recovered Error sense key, when the Method of Reporting Information Exceptions (MRIE)
field is set to a value of 0x3 in Mode Page 1Ch, or if the TapeAlert Mode option is set to Rec
Error (cnd). The default is Disabled.
Tape Alert Mode: Specifies conditions for logging and reporting TapeAlert data. The default is Tape Alert Mode Tape Alert Mode Tape Alert Mode
Logging Disabled.
Logging Disabled —Inhibits logging feature.
No Exceptions —Device should not report information exceptions.
Unit Attention —Report information exceptions with a Unit Attention sense key and an
ASC/ASCQ of 5D/00.
Rec Error (cnd) —Report information exceptions with a Recovered Error sense key and an
ASC/ASCQ of 5D/00, if Recovered Error Reporting is enabled.
Rec Error (unc) —Unconditionally report information exceptions with a Recovered Error
sense key and an ASC/ASCQ of 5D/00.
No Sense —Report information exceptions with a No Sense sense key and an ASC/ASCQ
of 5D/00.
On Request — Report information exceptions with a No Sense sense key and an
ASC/ASCQ of 5D/00, only in response to an unsolicited Request Sense command.