Configuring The Library; Setting A Scsi Id - HPE Compaq StorageWorks SSL2000 Series Maintenance And Service Manual

Configuring the Library

The Library is designed with many configuration options, each offering multiple settings to
support a variety of applications and platforms. The setting of each option is stored in non-
volatile memory in the unit. For most applications, you do not have to change the factory default
settings. If you need to change the configuration, go on to the next section. If you are uncertain
whether you need to change a setting, contact your Technical Support representative.
To change settings, use the control panel. For an overview of how the control panel works, and
a description of the functions of the buttons, indicators and display, see "Entering the Menu
Mode," "Exiting the Menu Mode," and "Navigating through the Menu Structure" in Chapter 2,
"Operation."
You can change the settings using the options contained in the Configuration menu described
later in this appendix. Refer to your host computer documentation to determine which settings
might need to be changed.

Setting a SCSI ID

1. Turn the Library on and wait until the Power-On Self Test (POST) terminates and the
Primary or Secondary Default screen appears on the display. You can toggle between the
two with the p and q buttons.
Loader Idle
Drv 0: No Tape
Drv 1: Unloaded
Or
Ready
0
10
2. At the Default screen, press the Enter
menu.
u Load/Unload
Remove Magazine
Maintenance Menu
Configure Menu
3. Press the q button three times to move the u to the Configure menu, then press the Enter
button. The screen displays the following Configure submenu. Note that the ¤ at the end
of the fourth line means you can scroll to additional configuration options using the q
button.
u SCSI Options
Library Options
Barcode Options
Set Element Base
_ _ _ _ _ _ _ 9
_ _ _ _ _ _ _ 18
Enter button. The screen displays the following Main Enter Enter
¤
£
Installation C-35
Enter
Enter Enter