Removing And Replacing The Power Switch; Figure 5-32. Power Switch Retaining Screws - HPE Compaq StorageWorks SSL2000 Series Maintenance And Service Manual

6. Replace the brace plate (see Figure 5-10).
7. Connect the Library to the AC power source.
8. Turn on the Library.

Removing and Replacing the Power Switch

To remove the power switch:
1. Unplug the Library from the power source.
2. Remove the power supply as described earlier in this chapter.
3. Remove the front panel as described earlier in this chapter.
4. Locate the power switch at the lower right of the Library chassis front, and then remove its
two retaining screws (see Figure 5-32).

Figure 5-32. Power switch retaining screws

5. Lift out the power switch.
To replace the power switch:
1. Position the power switch through the front of the Library chassis.
2. Replace the two retaining screws in front.
3. Replace the front panel as described earlier in this chapter.
4. Replace the power supply as described earlier in this chapter.
Parts Removal and Replacement 5-27
cc0102