Default Screen; Fault Screen - HPE Compaq StorageWorks SSL2000 Series Maintenance And Service Manual

Default Screen

After the POST diagnostics have concluded successfully and initialization is complete, the
following Default screen appears. Note that the Default screen consists of two pages.
Page 1 Default screen:
Loader Idle
Drv0: Ready or No Tape
Drv1: Idle
Page 2 Default screen:
Loader Idle
0
10
Page 1 displays the library and drive status. Page 2 displays the library status (Line 1) and
magazine slot status (Lines 3 and 4).
The library status lines show each slot as a rectangle. A solid block indicates that a cartridge is
present. A hollow block indicates that a slot is empty.
Line 4 also shows the status of the mail slot. A
slot. A symbol indicates that the mail slot is empty.
The F F F F , and G G G G buttons control which Default page is displayed.

Fault Screen

When a fault is detected, a screen similar to the one shown appears. In addition, either the Drive
Fault or the Loader Fault LED on the control panel lights.
Fault Code:
Elevator Jammed
Power Down to Clear
The first line shows a numerical FSC. The second line shows a brief description of the error.
The third and fourth lines contain a one- or two-line message describing the initial ERP.
For a list of FSCs and ERPs, see Chapter 4, "Troubleshooting."
_ _ _ _ _ _ _ 9
_ _ _ _ _ _ _ 18
3004
symbol indicates that a cartridge is in the mail
Operation 2-7