Installing The Panel Extensions; Figure C-8. Installing The Panel Extension - HPE Compaq StorageWorks SSL2000 Series Maintenance And Service Manual

Installing the Panel Extensions

NOTE: The left and right slides are the same so there is no risk of confusing the parts upon reassembly.
1. Place a panel extension against one side of the Library so that the holes in the panel
extension are aligned with the two holes in the chassis (see Figure C-8).

Figure C-8. Installing the panel extension

2. Install two screws through the holes in the panel extension into the Library.
NOTE: The panel extension has two pairs of mounting holes. Use the forward pair for the regular
mounting position (
outward from the front of the storage cabinet. The rear pair of holes permit a flush mount position that
leaves the front panel recessed into the storage cabinet (
mounting if, for example, you have storage cabinet doors that would be hindered by the protruding front
panel.
3. Repeat steps 1 and 2 for the other side of the Library.
Figure C-8). Regular mounting leaves the curved front panel surface extending


Figure C-8). You might choose flush

Installation C-9
2
1
cc0027