Setting Up Reserved Slots; How Reserved Slots Are Numbered - HPE Compaq StorageWorks SSL2000 Series Maintenance And Service Manual

7. Press the q button to move the move the u to Slave Address.
8. Press Enter Enter Enter to move the cursor to the number option on the fourth line. Enter
9. Use the q and p buttons to change the number.
10. Press Enter Enter Enter to save the selection. Enter
NOTE: The change will not take effect until you reboot.

Setting up Reserved Slots

Use this option to withdraw some of the slots in the Library from use as storage slots to meet
licensing requirements or to dedicate one or more slots as a cleaning slot.

How Reserved Slots are Numbered

Ordinary cartridge slots are numbered from the front of the magazine to the rear (see Figure
C-35). If you reserve one slot, it becomes Reserved Slot #1 in the last slot of the magazine. If
you reserve two slots, slot #17 becomes Reserved Slot # 1 , while slot #18 becomes Reserved
Slot #2 . Additional reserved slots continue in this rear-to-front pattern. If your software license
limits you to less than the full magazine capacity, Reserved Slot #1 always follows the last
unreserved data cartridge.
Installation C-39