2.4 Arti: Assignment Of Trunk Application Data - NEC NEAX 2400 IPX Programming Manual

COMMANDS CONCERNING ISDN DATA ASSIGNMENT

2.4 ARTI: ASSIGNMENT OF TRUNK APPLICATION DATA

RST (CDN1)
0
1
2
3
HMT (CDN2)
TRCRST (CDN3) Call Restriction by Information transfer rate in Bearer Capability Information Element
0
1
2
3-15 = –
TRSRST (CDN4) Call Restriction by Information transfer rate in Bearer Capability Information Element
0
1
2
3
4-15 = –
T309LNK (CDN5) Assignment of Timer T309 for Data Link Failure
0
1
2
3
T309CON (CDN6) Assignment of Timer T309 for Layer 1 Failure
0
1
2
3
LLCRST (CDN7) Call restriction by user rate in Low Layer Capability Information Element
0
1-31 = Call which includes this user rate value is restricte d
Note 1: User rate value is based on ITU-T Q-931.
DTRT (CDN11)
0
1
TMPRT (CDN12) Temporary Route Information over CCIS
0
1
CHAPTER 4
Page 22
Revision 1.0
Assignment of Restart
= Restart Send per Individual Channel
= –
= –
= Restart not Send
When assigning this data, zero (0) should always be entered.
= No restriction
= Data call restriction (Unrestricted digital, Restricted digital and Video data calls are
restricted.)
= Speech call restriction (Speech, 3.1 KHz audio and 7KHz audio calls are restricted.)
= No restriction
= 384 kbps (H0) call is restricted
= 1536 kbps (H11)/1920 kbps (H12) call is restricted
= 384 kbps and 1536 (H11)/1920 (H12) kbps calls are restricted
= Layer 2 Alarm with T309 is Disabled
= Layer 2 Alarm [Temporary] with T309 is Enabled
= Layer 2 Alarm [Permanent] with T309 is Enabled
= –
= Layer 1 Alarm with T309 is Disabled
= Layer 1 Alarm [Temporary] with T309 is Enabled
= Layer 1 Alarm [Permanent] with T309 is Enabled
= –
= No restriction
Detection of ALL 1 alarm signal (DTI Layer 1 alarm)
= –
= Detection of ALL 1 alarm signal as a Layer 1 alarm
= –
= In CCIS, the route information can be transferred by the call control messages.
Moreover, the call restriction can be checked referring to this route information.
NDA-24305
Note 1