Mitsubishi Electric MELSEC iQ-F FX5 User Manual page 181

Precautions
• When this table specified for last table, jump is not executed and operation ends normally after deceleration stop.
• In stepping operation, conditions are judged at completion of execution of the table immediately prior to control method [10:
Condition Jump], and the jump destination table is immediately executed.
• In continuous operation, conditions are judged when execution of that table two tables before is started. When the jump-
destination table is set to control method [10: Condition Jump], the conditions for that table are simultaneously judged and
the next destination table is executed.
• If a table located two or fewer tables before (after the condition is determined) is changed, the change is applied, but the
condition jump is executed using the settings from when the condition was determined.
• Jumps to the table set to control method [10: Condition Jump] must be three times or less in a row. After the fourth jump,
execution is stopped.
Related devices
■Special relays
• CPU module
Axis 1 Axis 2 Axis 3
SM5916 SM5917 SM5918
R/W: Read/write, : Not supported
• High-speed pulse input/output module
First module Second module
Axis 5 Axis 6 Axis 7 Axis 8
SM5920 SM5921 SM5922 SM5923
R/W: Read/write, : Not supported
■Special registers
• CPU module
Axis 1 Axis 2 Axis 3
SD5506 SD5546 SD5586
SD5511 SD5551 SD5591
R: Read only, R/W: Read/write, : Not supported
• High-speed pulse input/output module
First module Second module
Axis 5 Axis 6 Axis 7 Axis 8
SD5666 SD5706 SD5746 SD5786
SD5671 SD5711 SD5751 SD5791
R: Read only, R/W: Read/write, : Not supported
Axis 4 Name
SM5919 Positioning table data initialization disable
Third module Fourth module
Axis 9 Axis 10 Axis 11 Axis 12
SM5924 SM5925 SM5926
Axis 4 Name
SD5626 Positioning execution table number
SD5631 Positioning error (error occurrence table No.)
Third module Fourth module
Axis 9 Axis 10 Axis 11 Axis 12
SD5826 SD5866 SD5906
SD5831 SD5871 SD5911
High Speed I/O
Parameter

Name
SM5927 Positioning table data
initialization disable
High Speed I/O
Parameter


Name
SD5946 Positioning execution table
number
SD5951 Positioning error (error
occurrence table No.)
6.2 Operations of Control Method
R/W Reference
R/W Page 74
High R/W Reference
Speed I/O
Parameter

R/W Page 74
R/W Reference
R Page 73
R/W Page 74
High R/W Reference
Speed I/O
Parameter

R Page 73
 R/W Page 74
6 TABLE OPERATION
179
6