Sanken S06-4A005-B Instruction Manual page 86

F1202 State display selection
This function is used to select output data displayed on the 7-segment monitor on the operation panel in No-Units Display mode.
Code No. Function Name
F1202 State display selection
● Output voltage: the output voltage of inverter.
● DC voltage: the value of DC voltage applied to the inverter.
● Active power: the actual power consumed on load.
● Apparent power: the apparent power is used for displaying inverter output.
● Radiator temperature: internal radiator temperature.
● Command speed: the speed given by a command.
● PID feedback value: the feedback value of PID control.
● VIF analog input value: an analog signal value generated by voltage or current.
● Command frequency: the frequency given by a command.
The following display contents is shown only when the value of F1001 = 2, 3, 4, 5, 6.
● Output torque: ratio of output torque to the rated torque.
● Partial excitation current: the current value for providing motor excitation.
● Partial torque current: the current value for providing motor torque.
● Command torque: the torque given by a command.
The following display contents is shown only when the value of F1001 = 6.
● Detecting position: the detecting position in position control.(Option)
※ When three detecting positions are selected, even if the positioning is finished, "
F1203 Multiple for no-units display
This function is used when No-Units Display mode is displayed on the 7-segment monitor on the operation panel. This function is used
for setting the multiple which is multiplied with output frequency when F1202 = 1 (no-units display) .
Code No. Function Name
F1203 Multiple for no-units display
● This function is used in applications where linear velocity etc. is displayed in a simple way.
Data Content
No units multiple of
1： F1203）
（
2：Output voltage [V]
3：DC voltage [V]
4：Active power [kW]
5：Apparent power [kVA]
6：Radiator temperature [℃]
Command speed
7： [rpm]
8：PID1 feedback value [Hz]
PID2 feedback value
9： [Hz]
10： VIF1 analog input value [Hz]
analog input value
11：VRF/IRF
12：Reserved
Output torque
13： [%]
14： Partial excitation current [A]
Partial torque
15： current [A]
Detecting position
16： [mm]
29：Command frequency [Hz]
30：Command torque [%]
35：Reserved
target frequency
44： [Hz]
output frequency
45： [Hz]
Data Content
0～100
- 85 -
Setting Resolution
1
[Hz]
. " will not be displayed.
Setting Resolution
0.01
Factory Presets
1
Factory Presets
1