Sanken S06-4A005-B Instruction Manual page 167

※2: Set F1002=22 for frequency setting by serial communication.
(2) Setting of function codes related to the computer and serial communication
Code
F4001
F4003
F4004
F4005
F4006
F4007
F4008
F4009
F4010
F4011
F4101
F4102
F4103
Message checksum
Select whether to add a checksum to a communication message.
0: No
1: Yes (factory preset)
Selection of Pull-up/down ※1
Select pull-up/down for the RS485 communication circuit.
0: No (Factory preset)
1: Yes
Communication response time
Set a communication response time.
1～6000ms (Factory preset=10ms)
Serial communication
Select a serial communication.
0: No function (Factory preset)
1: Communication with dedicated protocol
2: Modbus communication
Inverter No.
Set the inverter number (Factory preset = 1)
·Please set value of 1-32 by a communication with the dedicated protocol.
·Please set value 1-254 by a Modbus communication.
Please set a number which is not the same with other numbers, otherwise, the inverter
may not work normally.
The inverters need not be numbered sequentially.
Communication speed
Set a communication speed
1: 1200bps
2: 2400bps
3: 4800bps
4: 9600bps
5: 19200bps
6: 38400bps
7: 57600bps
Parity bit
Set a parity bit.
0: No
1: Odd (Factory preset)
2: Even
Stop bit
Set a stop bit.
1: 1 bit (Factory preset)
2: 2 bits
End code
Set an end code.
0: CR＋LF (Factory preset)
1: CR
※No end code for BINARY and Modbus communication
Specified command INV response selection
Prevent the inverter from sending response message to the specified command message at
PC side.
0: Sent (Factory preset)
1: Not sent (Error response sent)
2: Not sent (Error response not sent)
Modbus communication timeout setting
Set a Modbus communication timeout
0: No function (Factory preset)
0.01-600s
Modbus communication timeout action
Set a Modbus communication timeout action.
0: keep the status (Factory preset)
1: Stop alarm
Modbus register address translation
Description
- 166 -