Sanken S06-4A005-B Instruction Manual page 75

Set frequency
Input
signal
1st
F1021 JOG frequency
A function for setting frequency in JOG operation.
Code No. Function Name
F1021 frequency
JOG
● Selection of the jog operation mode (control input terminals JOG-DCM1 or JOG-DCM2 are short-circuited) allows the JOG
frequency to be specified jointly by the operation panel's quick knob and stepping mode.
Note: As long as the JOG operation mode is selected, this mode takes precedence and cannot be changed to any other
multi-speed frequency.
st
F1022
1 Start of S-shaped acceleration
F1023 st
1 End of S-shaped acceleration
Gradient of middle of 1
F1024
st
F1025 1 Start of S-shaped deceleration
st
F1026 1 End of S-shaped deceleration
Gradient of middle of 1
F1027
Deceleration
nd
F1028
2 Start of S-shaped acceleration
nd
F1029
2 End of S-shaped acceleration
Gradient of middle of 2
F1030
Acceleration
nd
F1031 2 Start of S-shaped deceleration
nd
F1032 2 End of S-shaped deceleration
Gradient of middle of 2
F1033
Deceleration
A function which provides variable shape of acceleration/deceleration curve when S-shaped acceleration/deceleration (F1010 = 2) is
set in the acceleration / deceleration mode. Set F1414-F1421=84, and if the terminal is put at ON, the 2nd S shape is selected, and OFF
the 1st S shape.
Time
2nd 3rd 4th
Acceleration time
Data Content
st
S-shaped Acceleration
st
S-shaped
nd t
S-shaped
nd
S-shaped
Short-circuit between AD2 and DCM1/2
Short-circuit between AD3 and DCM1/2
1st 2nd 3rd 4th
Deceleration time
0～60Hz
- 74 -
Operation signal
(Operation panel or external signal)
Setting Resolution Factory Presets
0.01 Hz 5