Sanken S06-4A005-B Instruction Manual page 164

Recommended Function code value
No. No. Function Name
1 F1001 Motor control mode selection
2 F8007 Water supply Optional modes
3 F3201 PID control action selection
4 F1101 Operation command selection
5 F1109 Direction of rotation of motor
6 F1007 Upper frequency limit
7 F1008 Lower frequency limit
8 F1012 1st acceleration time
9 F1016 1st deceleration time
10 F1003 V/f pattern
11 F1004 Torque boost
12 F1102 Starting method
The following is the set of command and feedback
13 F8022 Pressure command
14 F3002 Switch analog input
15 F8023 Offset
feedback
16 F8024 Pressure
feedback
17 F8025 The ratio of pressure upper limit
18 F8026 The ratio of pressure lower limit
19 F8027 The slope of pressure
acceleration and deceleration.
20 F3003 P gain
21 F3004 I gain
22 F3005 D gain
23 F1104 Operation start frequency
24 F3007 Filtering time constant
Please make sure and regulate the following set
25 F1108 Restart after momentary power
failure
*1：If the momentary restart is set for valid, the over current may be occur when reset, please take care of that case.
Note: To avoid the function code being affected from unreasonable setting code, when the single-pump mode needs to apply
at the sleep/auxiliary pump, we strongly recommended the following function code: F1008 ≥ 10Hz；F1104 = 0.01Hz
Recommended
Value
1
15
1
1 or 2
2
45～50 Hz
20～35 Hz
5～30 sec
5～30 sec
2
0 %
1
0.100～2.000MPa
7
pressure of analog
0.000～±9.999
gain of analog
Set pressure upper
limit according to
actual commend
Set pressure lower
limit according to
actual commend
0.01～0.4
0.1～5.0
0.1～5.0
0
1～10 Hz
10
0 or 1
(Note)
Please make sure the value at the beginning
Single-pump water supply mode
Set automatic restart for 2 at the power off
Fixed at the positive direction
Set it according to the use of pump
Set to without overcurrent and overvoltage
set it according to pump
Set it according to use. F8029 is second pressure
command.
VRF/IRF：4～20mA
Set it according to pressure sensor.
VRF/IRF (at 7): 4～20mA
Be used in the situation of pressure command is
error.
Setting for the rate of change of pressure
command.
Please increase it with set value when the
command is less than 1Mpa.
Keep it for 0
Please increase the set when stop the inverter by
signal of potentiometer and set it more than 0 when
the inverter needs to standby.
About 100ms
Set it for 1 when needs to restart after power
failure. *1
- 163 -