Sanken S06-4A005-B Instruction Manual page 103

● F1604=1: Initialize to factory presets
Function codes are initialized to factory presets.
● F1604=2: Motor parameters measured by auto tuning are invalid.
Return to the motor's initial value of the parameters measured by auto tuning selected by F5001.
If the motor's initial value can not be stored in the inverter, the parameters measured by auto tuning will be initialized to factory
presets.
Parameters measured by auto tuning: F5009-F5014.
● F1604 = 3, 99: user data related
User data initialization and data confirmation shall be carried out in accordance with the following operation sequences.
(Sequence1) Setting the initial value of user data.
1. Set the required function code.
2. Confirm the user's initial value with F1604=99.
3. Check that "
4. " " keeps flashing while the user's initialization value is being stored. Wait until "
5. Once " " has disappeared, the function code data can be initialized to the user's initial value with F1604=3.
(Sequence 2) Initialization of the user data
1. Set F1604=3 to initialize the data determined by F1604=99.
2. Check that "
3. " " keeps flashing while the user's data is being initialized. Wait until "
4. When " " disappears, the user's data initialization is completed.
Note 1: In operations where the initial value is used, "
this purpose.
Note 2: As an exception, F1804 and F1805 can not be initialized.
Note 3: When the user's initial value is not determined, "
initialization) is executed.
Note 4: In serial communication function,
" is displayed and that the set value is flashing, press【UP】key to confirm.
" is displayed and that it is alternately displayed with the set value, press【UP】key to confirm.
"
" is displayed for confirmation. Now, the UP】key is used for
" will be displayed if F1604 = 3 (the user's data
, and
- 102 -
" disappears.
" disappears.
are not displayed.