Sanken S06-4A005-B Instruction Manual page 180

List of error codes during function setting
⑷
BIN
ASCⅡ
"exxxx"
"eFFF0" F0H
"eFFF1" F1H
"eFFF2" F2H
"eFFF3" F3H
"eFFF4" F4H
"eFFF5" F5H
"eFFF9" F9H
"eFFFA" FAH
"eFFFB" FBH
"eFFFC" FCH
"eFFFE" FEH
ASCⅡ: ASCⅡ-format message communication
BIN: BINARY-format message communication
List of inverter alarm codes
⑸
Alarm No.
1
2
3
4
5
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
Third byte
Fourth byte
Setting value conflicts with function code number Fxxxx
Normal setting
Function code value is out of range, user's initial value is not determined, or motor
constant is not registered.
Function code setting conflicts with mounted optional board
Function code setting conflicts with mounted options
Unable to change function code during inverter operation
Unable to change function code with operation function locked
Unable to change function code during LV
Frequency setting is not permitted (check the setting values of F1002)
Inverter control microcomputer busy (send the message again)
Reserved
Access to undefined code (access the code, which cannot be accessed, in serial
communication function)
Alarm code
AL1 Memory abnormality
AL2 System abnormality
AL3 System abnormality
AL4 System abnormality
AL5 System abnormality
AL9 System abnormality
AL10 System abnormality
ACER Overload protection during acceleration
CNER Overload protection during constant speed
DCER Overload protection during deceleration
ES External heat sensor abnormality
OH Radiator temperature abnormality
LVA Undervoltage during acceleration
LVN Undervoltage during constant speed
LVD Undervoltage during deceleration
OCH Main switch element temperature abnormality
OCA Overcurrent during acceleration
OCN Overcurrent during constant speed
OCD Overcurrent during deceleration
OCPA Momentary overload during acceleration
bit0: Reserved: 0
bit1: Reserved: 0
bit2: Reserved: 0
bit3: Reserved: 0
bit0: Reserved: 0
bit1: Reserved: 0
bit2: Reserved: 0
bit3: Reserved: 0
Error description
Description
- 179 -