Sanken S06-4A005-B Instruction Manual page 192

8-2-1 List of conflict & interference error
Table 8-2 List of conflict & interference error
Setting function code
No. Name
1001 Motor control mode
selection
st
1002 1 speed frequency
setting
1003 V/f pattern selection
1007 Upper frequency limit
1008 Lower frequency limit
Error code
Setting
All E5001
(excluding
1 & 40)
E1007/E1316/E1317
2 E1901
3 E1002
E1901
4 E1901
E2201
E3201
5 E1002
E1901
E2201
E3201
6 E1002
E1101
E1901
E2201
E3201
10,11 E1901
E2201
E3201
40 E1901
E2201
E3201
All Exxxx
Exxxx
2～20
26～28
25 E1001
2, 3 E2007
All E1008
E1001
All E1007/E1316/E1317
- 191 -
Description
The setting motor cannot be used in vector
control
Exceed the upper frequency limit
Simple energy-saving function (only in V/f
mode) cannot be used in vector control mode
Cannot set PG input repeatedly
Simple energy-saving (only in V/f mode), cannot
be used in vector control mode
Energy-saving mode cannot be used in torque
control
Pattern, disturb operation cannot be used in
torque control
PID control action cannot be used in torque
control
Cannot set PG input repeatedly
Energy-saving mode cannot be used in torque
control
Pattern, disturb operation cannot be used in
torque control
PID control action cannot be used in position
control
Cannot set PG input repeatedly
Position control mode is only effective when
operation command is external terminal
Energy-saving mode cannot be used in position
control
Pattern, disturb operation cannot be used in
position control
PID control action cannot be used in torque
control
Energy-saving mode cannot be set when motor
parameter are measured automatically
Pattern, disturb operation cannot be set during
automatic measurement
PID control action cannot be set during automatic
measurement
Energy-saving mode cannot be set during V•f
separation control
Pattern, disturb operation cannot be set in V•f
separation mode
PID control action cannot be set in V•f separation
mode
Cannot set analog input repeatedly
Cannot set analog input repeatedly
st
When 1 speed frequency is pulse train input
(optional function), the required PG sensor
control mode cannot be used
Automatic torque compensation and square ratio
lowing mode cannot be used together
Upper frequency limit cannot be smaller than
lower frequency limit
Exceed the possible upper frequency limit
Lower frequency limit cannot be larger than