IDK MSD-72 Series Command Reference Manual page 80

MSD-72 series Command Guide
@GEC / @SEC
Getting Command
Response
Setting Command
Response
Parameter
80
Control command (Communication command)
@GEC, no
@GEC, no, delay, port, memo, length, command, timeout, retry, interval,
retryover, display (, recv_1, recv_2･･･)
@SEC, no, delay, port, memo, length, command, timeout, retry, interval,
retryover, display (, recv_1, recv_2･･･)
@SEC, no, delay, port, memo, length, command, timeout, retry, interval,
retryover, display (, recv_1, recv_2･･･)
no: Control command number
1 to 32
delay: Delay time
0 = 0 to 999999 = 999.999 seconds
port: Output port
1 to 2047
bit 7 6
LAN LAN LAN
port
6 5
bit 15 14
－ －
port
"1" is for the bit of the output port to send a command (Since bit 11-15 are not
used, they are always "0"). For example, if you want to send a command from
RS-232C CH1, specify "1"(0000000000000001 in binary). If sending a
command from LAN 2, specify "8" (0000000000001000 in binary).
memo: Memo
Up to 14 characters of 20 to 7D except 2C (,).
length: Data size of send command (the number of bytes)
0 to 30
command: Send command data
Specify length × 2 digits with 0 to 9, A to F, a to f: (4 bit per digit in
hexadecimal).
timeout: Time-out time
0 = 0 to 99999 = 99.999 seconds
retry: The number of retries
0 to 99
interval: Retry interval
0 = 0 to 99999 = 99.999 seconds
retryover:
0 = Stop processing, 1 = Continue processing
display: Displaying received data
0 = communication command control
recv_1-32: Checking response command check
1 to 32
Getting commands: each response command number is separated from each
other by a comma.
Setting commands: the response command number is separated from each
other (up to 32 commands) by a comma. For setting commands that are not
specified, "Not check" is set.
Register response commands in "@GRC / @SRC".
5 4 3 2
LAN LAN LAN
4 3 2 1
13 12 11 10
LOOP
－ － －
BACK
1 0
RS-232C RS-232C
CH2 CH1
9 8
LAN LAN
8 7