IDK MSD-72 Series Command Reference Manual page 87

@GCC / @SCC
Getting Command
Response
Setting Command
Response
Parameter
Getting Command
example Response
Description Getting control commands that will be executed when the MSD is powered on.
Setting Command
example Response
Description Executing in order of control command 5, 2, and 1 when the MSD is powered on.
Remarks
Control command link
@GCC, event
@GCC, event, c_1 (, c_2, c_3･･･)
@SCC, event, c_1 (, c_2, c_3･･･)
@SCC, event, c_1 (, c_2, c_3･･･)
event: Control command execution condition
For settable values, see the table below.
c_1-10: Desired command
0 = Not link [Default], 1 to 32 = Control commands1 to 32
Control commands that are registered in one of the following commands can be
linked:
@GEC / @SEC Control command (Communication command),
@GEC / @SEC Control command (Displaying received data),
@GEC / @SEC Control command (contact closure),
@GEC / @SEC Control command (CEC)
@GCC,19
@GCC,19,5,2,1
Executing in order of control commands 5, 2, and 1.
@SCC,19,5,2,1
@SCC,19,5,2,1
－
MSD-72 series Command Guide
87