IDK MSD-72 Series Command Reference Manual page 49

@GSM / @SSM
Getting Command
Response
Setting Command
Response
Parameter
Getting Command
example Response
Description Getting the set automatic measurement mode when unregistered signal is input.
Setting Command
example Response
Description Setting the automatic measurement to be executed when unregistered signal is
Remarks
@RTT
Setting Command
Response
Parameter
Setting Command
example Response
Description Reconfiguring IN1 input timing setting to the value detected automatically.
Setting Command
example Response
Description Setting IN6 input timings to the values saved in the device table 2.
Remarks
Automatic measurement when unregistered signal is input
@GSM
@GSM, mode
@SSM, mode
@SSM, mode
mode: Automatic measurement
0 = Not execute, 1 = Execute [Default]
@GSM
@GSM,1
@SSM,1
@SSM,1
input.
－
Loading device data
@RTT, ch (, table)
@RTT, ch (, table)
ch: Input channel
1 = IN1 to 9 = IN9
table: Device table
1 to 99 (Registered device data),
100 to 100+n (Preset device data. "n" varies depending on input signal, but
0 for most cases.)
Only for analog input, specify the device table.
@RTT,1
@RTT,1
@RTT,6,2
@RTT,6,2
This command is valid only if signal is input.
For analog input, this command is valid only if the device data of input signal is
registered.
MSD-72 series Command Guide
49