Setting Up Lan Communication - IDK MSD-72 Series Command Reference Manual

MSD-72 series Command Guide

2.2.3 Setting up LAN communication

(1) Connect the MSD and the control device via a LAN cable.
(2) Set up LAN communication as follows:
・Set IP address and subnet mask
・Operation mode of LAN communication: "RECEIVER"
・TCP pot number: 23, 1100, 6000 to 6999
(3) Establish the connection from the control device to the IP address and TCP port that are set to the
MSD in step (2) above.
(4) Send a communication command from the control device to the MSD in order to check the control
status of the MSD.
Step(3)
Laptop
(Controller)
10
Step(4)
Step(1)
LAN cable
Communication
commands
Step(2)
[Figure 2.6] Setting RS-232C communication
【Reference: User's Guide】