Room Units - Siemens Climatix Series Basis Document

Devices
Prerequisites
Commission room
units
Note
Parameter
Parameter
Energy meter EM24
Settings
Inputs

Room units

Settings
Inputs
Reset required !!
Siemens
Building Technologies
9.5 Room units
A process interface to connect room units is always available on the basis control-
ler POL636.xxx. The application is designed for a maximum of 2 room units.
9.5.1 Commission room unit
Participating devices
− Climatix POL 636 controller.
− Climatix POL 822.60 room unit.
Requirement for commissioning room units:
– Commission of the SAPRO application is completed a constellation with room
unit is selected in the System Parameter > Configuration 1 under Room tmp
sensor (you can also select is in the menu Main index > Integrations > Room
unit) .
– Level 4 (password 2000).
– Mapping file (OBH.bin) is loaded.
Step Action
1 Select a constellation with room unit in the menu System Parameter >
Configuration 1 under Room tmp sensor.
2 Configure additional settings as required.
See as well Section 4.5 Room units.
Main Index > Integrations
Range
− No
− Yes
− 1 sensor
− 2 sensors
− 1 RU
− 1snsr+ RU
− 2 RU
− 
− Execute
Basis Document Siemens Climatix Control System
Standard application AHU
BDCX.100820.01GB
Communication
Function
No energy meter selected.
Go to page with all settings relevant to parame-
terizing energy.
Go to page with inputs.
Inputs for room temperature sensor. You can
select whether to apply maximum, minimum,
average or individual value for control for more
than one sensor in Configuration 2. When select-
ing 1 RU, 1snsr+RU or 2 RU, the interface to the
room unit connection is enabled.
Goes to page with all settings relevant to param-
eterizing room units.
Go to page with temperature inputs.
As a matter of principle, the controller must be
set after parameterization to assume the data.
131 / 244
CE1P3977en_02
Page 131
01.02.2010