Packing, Transport And Storage; Maintenance And Service; Environmental Protection And Waste Management; Abbreviations - Siemens Climatix Series Basis Document

Packing
Transportation
Storage
Cleaning
Faults
Environmental
protection
Waste management
Siemens
Building Technologies
2.4

Packing, transport and storage

The required packing of the system for storage and transport is dependent on the
mechanical and climate conditions.
Use the original packaging from Siemens or from the supplier when mechanical
and climate conditions have an impact on transport.
During transport under particularly difficult conditions, a special package must be used.
If the equipment is not to be installed immediately, store it in a well ventilated area,
protected against high temperatures, humidity, dust and metal particles.
• For storage and transport, the limit values specified in data sheet CE2Q3226
always apply.
Contact your supplier or Siemens in the event of any uncertainty.
• Damage that arises as a result of incorrect packing, storage or transport is not
the responsibility of Siemens.
2.5

Maintenance and service

All that is required to maintain POL63x is regular cleaning. System components
that are arranged within the control panel are most easily separated from dust and
dirt in conjunction with the prescribed maintenance checks.
Diagnostics, the rectifying of faults and restarting may only be carried out by
authorised staff. This also applies to work within the control panel (e.g. inspections,
replacing fuses).
In the event of unauthorised interventions, Siemens cannot undertake to honour
any guarantees. The responsibility for any damage that occurs in the system and
any consequential damage rests with whoever caused the damage.
2.6 Environmental protection and waste
management
Process unit POL 63X has no negative impact on the environment.
The apparatus includes electrical and electronic components and when discarded
must not be handled together with household waste. Always observe local regu-
lations!
2.7

Abbreviations

HMI Human Machine Interface (operating unit)
KP Gain factor (P-effect)
LED Light emitting diode
NC Normally Closed (opening contact)
NO Normally Open (closing contact)
SD Secure device
TN Integral action time (I-time)
Basis Document Siemens Climatix Control System
Standard application AHU
BDCX.100820.01GB
Philosophy of air handling units
11 / 244
CE1P3977en_02
Page 11
01.02.2010