Siemens Climatix Series Basis Document page 172

HW IO
Supply fan DO1
Supply fan DO2
Supply fan DO3
Exhaust fan DO1
Exhaust fan DO2
Exhaust fan DO3
Supply fan AO
Exhaust fan AO
Terminal positions for
digital outputs
Terminal positions for
analog outputs (0...10 V
DC)
HW IO
El heating AO
El heating DO1
172 / 244
Basis Document Siemens Climatix Control System
Siemens
Page 172
BDCX.100820.01GB
Building Technologies
15.3.9 Outputs: Fans
The listed hard assignments are possible for fans.
Pos
NUsd,Comm,DO1..DO24
NUsd,Comm,DO1..DO24
NUsd,Comm,DO1..DO24
NUsd,Comm,DO1..DO24
NUsd,Comm,DO1..DO24
NUsd,Comm,DO1..DO24
NUsd,Comm,X3...X28,AO1...AO22
NUsd,Comm,X3...X28,AO1...AO22
Position Explanation
DO1...DO6 Terminal on basis controller.
DO11...DO14 Terminal on extension module 1.
DO21...DO24 Terminal on extension module 2.
Comm This output is connected via communication and therefore does
not occupy a hardware input. Some output signals can also be
connected via communication (see lists in the documentation on
the basics for LON, ModBus, BacNet).
Outputs may generally be enabled in parallel as well (via hardware
and communication).
NUsd No used: The hardware position is not yet selected. The plant is
locked against switching on if an enabled sensor is set to NUsd
and the following fault issued: NotConfigured (Function enabled,
but hardware not assigned).
Position Explanation
X3...X8 Terminal on basis controller.
AO1,AO2 Terminal on basis controller.
X11...X18 Terminal on extension module 1.
AO11,AO12 Terminal on extension module 1.
X21...X28 Terminal on extension module 2.
AO21,AO22 Terminal on extension module 2.
Comm This output is connected via communication and therefore does not
occupy a hardware input. Some output signals can also be con-
nected via communication (see lists in the documentation on the
basics for LON, ModBus, BacNet).
Outputs may generally be enabled in parallel as well (via hardware
and communication).
NUsd No used: The hardware position is not yet selected. The plant is
locked against switching on if an enabled sensor is set to NUsd
and the following fault issued: NotConfigured (Function enabled,
but hardware not assigned).
15.3.10 Outputs: tmpControl
The listed hard assignments are possible for all outputs.
Pos
NUsd,Comm,X3..X28,AO1...AO22
NUsd,Comm,DO1..DO24
Standard application AHU
Configuration
CE1P3977en_02
01.02.2010