Siemens Climatix Series Basis Document page 89

Prerequisite
Function
Parameter
Parameter
Kick date / time
Kick interval
Kick on time
Note
Prerequisite
Enable
Parameter
Fan comp humidity
Function
Siemens
Building Technologies
5.11.7 Humidifier pump kick
Pump kick is enabled.
Main Index > Configuration > Configuration 2 > Humidifier pump = Yes+Kick
The pump is switched on for a short period for longer idle periods. This prevents
lock up.
Main Index > Unit > Humidity control > Humidification > Pump
Range
Mo 00:00...So 23:29
0.0...36000.0 [h]
0.0...36000 [s]
Kick date/time = * *:* and kick interval = 0 --->
No pump kick is run.
5.11.8 Fan compensation
Main Index > Configuration > Configuration 1 > Room hum sensor = Yes
Main Index > Configuration > Configuration 2 > Fan comp humidity = Yes
Main Index > Configuration > Configuration 2
Range
– No
– Yes
The controller output reduces or increases the fan setpoint relating to the maximum
allowable fan compensation (See as well Fan compensation).
Fan setpoints are increased or decreased, if:
– KP > 0: Room humidity < setpoint.
– KP < 0: Room humidity > setpoint
Basis Document Siemens Climatix Control System
Standard application AHU
BDCX.100820.01GB
Functions
Function
Weekday and time for pump kick. Sets the weekday
(Mon...Sun) and time to run the pump kick.
Examples:
Mon *:* Each Monday at midnight.
Sat 07:* Each Saturday at 7:00 am.
* *:* Time is not relevant; the kick interval applies
accordingly.
Idle time for pump kick. Set the idle time after which a
pump kick is run. Examples:
168 After 168 hours.
123.4 After 123 hours and 24 minutes.
0 Idle time is not relevant; kick date/time applies
accordingly.
Set the period for the pump kick.
Examples:
10 Period = 10 seconds.
0 Period = 1 controller cycle (ca. 150 ms).
Function
Room-temperature dependent fan compensation.
89 / 244
CE1P3977en_02
Page 89
01.02.2010