17.15 Temperature Control - Siemens Climatix Series Basis Document

Main Index > Unit > Fan Control > Exhaust fan > Setpoints/Settings > Deviation alarm
Parameter Function
Alarm Actual Status Exhaust Deviation alarm
Min limit Lowest allowed Present Value for alarm
Maximum deviation In maximum allowed Deviation
Start up delay Delay until the Deviation is supervised
Main Index > Unit > Fan Control > Summer comp
Parameter Function
Outside tmp start Start Temperature for Summer
compensation
Outside tmp end End Temperature for Summer
compensation
Delta delta for Summer compensation
Main Index > Unit > Fan Control > Winter comp
Parameter Function
Outside tmp start Start Temperature for Winter compensation -64...64
Outside tmp end End Temperature for Winter compensation
Delta delta for Winter compensation
Main Index > Unit > Fan Control > OpHoursSettings
Parameter Function
Op hours alarm Operation hours alarm
Enble ophours alarm Enables this Function, if the Operation
Hours from Supply Fan are > than
Operation Hours Limit => alarm
Op hours limit Operation hours Limit
Main Index > Unit > Temp control
Parameter Function
Act controlled tmp Actual Value of the controlled Temperature
Tmp setpoints Jumpline to tmp Setpoints
Cascade controller Actual Heating Setpoint; Actual Cooling
SetpointJumpline to settings for Cascade
Controller
Min/max ctrlr sply Jumpline to settings for Min Max Controlling
Hrec damper Actual Value; Jumpline for Heat recovery
Damper settings
Heat recovery Actual Value; Jumpline for Heat recovery
settings
Heating Actual Value; Jumpline for Water Heating
settings
Electrical heating Actual Value; Jumpline for electrical Heating
settings
Cooling Actual Value; Jumpline for Cooling settings 0...100%
Heating 2 Actual Value;Jumpline for Heating 2 settings 0...100%
Siemens
Building Technologies
17.14.7 Exhaust fan deviation alarm
17.14.8 Fan summer cmp
17.14.9 Fan winter cmp
17.14.10 Fan OpHoursSettings

17.15 Temperature control

17.15.1 Start page
Basis Document Siemens Climatix Control System
Standard application AHU
BDCX.100820.01GB
HMI
Value range Unit
Active...passiv
-64...64 °C
-64...64 °C
0...36000 --- S ---
Value range Unit
-64...64 °C
-64...64 °C
-100...100 %
Value range Unit
°C
-64...64 °C
-100...100 %
Value range Unit
Active*Passive
No*Yes
0...999999 h
Value range Unit
°C
-64.0...64.0 °C
0...100% %
0...100% %
0...100% %
0...100% %
%
%
Standard R S Link
X
10 6 Section:
10 6
5.4.5
60 6
Standard R S Link
25.0 6
30.0 6 Section:
5.4.4
0.0 6
Standard R S Link
5.0 6 Section:
-20.0 6
5.4.4
0.0 6
Standard R S Link
Passive 6
No 6 Section:
5.4.6
17520 6
Standard R S Link
x
6
6
6
6
6
6 Section:
5.5.1
6
6
197 / 244
CE1P3977en_02
Page 197
01.02.2010