If A System Error Occurs - Horizon Fitness Bookletmaker SPF-200A Manual

5-1 If an Icon Is Displayed on the Error Screen

5-1-2 If a System Error Occurs

If a system error icon is displayed on the screen, check the error code next to the icon, and clear the
cause of the error. See the tables shown below.
This icon indicates that
the machine has a system
error.
Error Code
Error Code Description
0 to 99 Whole System
TBC-200L Transport
93
Belt Deceleration
HOF Error During
94
Changeover
HP-200A/200L Transport
95
Belt Speed Lowering
Fore-edge Trim Section
96 Transport Speed Lower-
ing
97 Upstream Device Error
98 Sheet Infeed Error
99 Standby Error
100 to 199 SPF Section Jam
Upstream Device Com-
100
munication Error
SPF Section Emer-
101
gency Stop
Upstream Device Signal
102 Error (Segmentation
Signal)
107 Fold Section Cover Open
No Manual Feeding
110
Sheets
Manual Feeding Sheets
111
Transport Error
120 Infeed Section Cover Open
121 Jog Section Cover Open
130 Infeed Section Jam
90
11119
50102A1
The transport speed of the top and bottom trim section is set slower than that of the
SPF. If the problem occurs again, please call your local dealer.
Clear the error displayed on the control panel of the HOF.
The transport speed of the HP-200A is set slower than that of the upstream device. If
the problem occurs again, please call your local dealer.
The transport speed of the fore-edge trimming section is set slower than that of the
upstream device.
If the problem occurs again, please call your local dealer.
Clear the error on the upstream device. This error is also displayed if Test Collating
on the collator or Test Feeding on the HOF is not complete.
The sheets are not transported to the SPF-200A/200L within the correct time after the
binding operation has started.
Check for sheet jams inside the upstream device.
The machine did not go to the Standby mode within the allowable time.
If the problem occurs again, please call your local dealer.
Check if the connector with the upstream device is connected to the SPF-200A/200L
correctly, and that the upstream device is powered on.
Turn the Emergency Stop button to release it.
1. When is selected, the manual feed timing did not match the feed timing of
the collator.
-Feed the sheets manually to match the feed from the collator.
-If the problem occurs again, use
fed from the collator).
2. The SPF-200A/200L does not receive the segmentation Signal from the upstream
device, therefore, the SPF-200A/200L does not work normally. Check that the posi-
tion of the VAC delivery sensor is correct. Connect and disconnect the connection
cable between the SPF-200A/200L and the upstream device.
3. If the segmentation signal is invalid temporarily, the feed error occurs and the error
icon appears.
Close the cover.
No sheets for manual feeding are loaded. Load the sheets for manual feeding in the
manual feed section and restart the binding operation.
Although the manual feeding operation was performed, the sheet was not fed.
Close the cover.
Close the cover.
There is a sheet jam in the infeed section. Open the cover and remove the sheets.
If a sheet is not jammed, the sensor may be dirty. See Section 6-5-3 and clean the sensor.
Press this button to clear
the error.
Cause and Solution
Cause and Solution
(Sheets are fed manually under the sheets