Operation - Horizon Fitness Bookletmaker SPF-200A Manual

8-5 Mis-stitch Detector SDS-200

8-5-2 Operation

1
Set up the job on the Setting
Screen and do the changeover.
- The SDS-200 cannot be used in the corner
stitching operation.
The mis-stitch detector can be used in
the range of sheet size as follows.
- Saddle Stitch and Fold Only
For the SPF-200A
Max. : 356 mm x 508 mm (14.000" x 20.000")
Min. : 120 mm x 275* mm (4.725" x 10.827")
For the SPF-200L
Max. : 356 mm x 610 mm (14.000" x 24.000")
Min. : 120 mm x 275* mm (4.725" x 10.827")
*When the stitch distance is 195 mm or more
(with the large saddle stitch stopper) or 150
mm or more (with the small saddle stitch
stopper), the minimum length is 180mm.
- Top/Side Stitch
Max. : 356 mm x 380* mm (14.000" x 14.960")
Min. : 180 mm x 138 mm (7.090" x 5.435")
*When the stitch distance is 195 mm or more
(with the large saddle stitch stopper) or 145
mm or more (with the small saddle stitch
stopper), the maximum length is 432mm.
The sensor may hit the stopper depending
on a binding pattern or a type of saddle
stitch stopper (large or small). In case that
the stitch detection is not available, the
remove screen is displayed. Disconnect
the connector of the sensor and remove
the sensor from the magnet.
2
Install the sensor units as shown
to the right so that the sensor
comes behind the clincher.
3
Connect the connector of the sensor.
4
Start binding.
182
CAUTION
Remove Screen
2110280501C1
21102
80502D1
8-5-2
Operation
21102
80502C1