Horizon Fitness Bookletmaker SPF-200A Manual page 105

5-1 If an Icon Is Displayed on the Error Screen
HP-200A
4200 to 4299
Home Positioning Error
M13 Transport Belt Up/
4213 Down Motor Home Posi-
tioning Error
M14 Stopper Up/Down
4214 Motor Home Positioning
Error
M15 Stopper Move Motor
4215
Home Positioning Error
M20 Punch Driving Motor
4220
Home Positioning Error
Fore-edge Trim Section
4300 to 4399
Home Positioning Error
M11 Booklet Stopper
4311 Move Motor Home Posi-
tioning Error
M12 Booklet Stopper
4312 Up/Down Motor Home
Positioning Error
M13 Transport Belt Up/
4313 Down Motor Home Posi-
tioning Error
M20 Fore-edge Trim
4320 Knife Motor Home Posi-
tioning Error
Top and Bottom Trim Sec-
4400 to 4499
tion Home Positioning Error
6000 or
Option System Error
above
6001 TB-200 Inverter Alarm
HOF
7000 to 7002
Communication Error
7000 HOF Response Error
HOF Response verifica-
7001
tion Error
HOF Changeover Not
7002
Complete
SPF Section
7100 to 7199
Communication Error
ARCNET Communica-
tion (No Response)
7100 Error (SPF QPM221-
QPM236-Downstream
Device)
Panel Control Board
7101 QPM221 Communica-
tion Error
Control Board Commu-
7102
nication Error
Please call your local dealer. After you press OK to correct the error, the machine will
do a changeover. At this point, the transport belt up/down motor is not at the correct
position, and does not operate during book binding.
Please call your local dealer.
Please call your local dealer. After you press OK to correct the error, the machine will
do a changeover. At this point, the punch section stopper is not at the correct position.
Please call your local dealer.
Please call your local dealer.
After you press OK to correct the error, the machine will do a changeover. At this
point, the booklet stopper is not at the correct position, and it may interfere with other
moving parts.
(This error will not be displayed again as long as the machine is homed again.)
The binding operation can be continued temporarily, but the booklet quality is not
guaranteed.
Please call your local dealer.
Please call your local dealer.
After you press OK to correct the error, the machine will do a changeover. At this
point, the transport belt is not at the correct position, and it may interfere with other
moving parts.
(This error will not be displayed again as long as the machine is homed again.)
The binding operation can be continued temporarily, but the booklet quality is not
guaranteed.
Please call your local dealer.
Refer to the user's manual for TBC-200L.
Turn off the power switch, wait about 10 minutes, then turn it on again.
If the problem occurs again, please call your local dealer.
There is no response from the HOF.
Check if the cable between the SPF and the HOF is connected correctly.
If the cable is OK, please call your local dealer.
There is no response from the HOF.
Check if the cable between the SPF and the HOF is connected correctly.
If the cable is OK, please call your local dealer.
The SPF and the downstream device finish the changeover, but the HOF does not
finish the changeover.
Check if the power for the HOF is turned on.
Check that there are no errors on the HOF.
Check the wiring between the devices. If the wiring is OK, please call your local
dealer.
Please call your local dealer.
Please call your local dealer.
Cause and Solution
Cause and Solution
Cause and Solution
Cause and Solution
Cause and Solution
5
97