7-10Synchronizing Between The Devices - Horizon Fitness Bookletmaker SPF-200A Manual

7-10 Synchronizing Between the Devices
The transport speeds for all of the devices are
set automatically so the sheets move
smoothly between the units.
1
Display the Transport Speed
Adjustment screen screen.
- Press the
screen.
2
Press the
press the
Each device starts to run and the system fig-
ures out the best operating speed. (It takes
about three or four minutes before the system
figures out the best operating speed.)
After the buzzer beeps, the
be pressed.
- If you want to increase the machine speed
above the automated setup speed, press
the icon and enter the increase rate in
the range from 1 to 10%. Increasing the rate
too much may cause unstable transportation
of the sheets.
If the sheet is not transported stably, set up
the speed manually. Change the icon from
to
the speed of the upstream device directly.
3
Press the icon.
The Save screen is displayed.
4
Press the
The settings are saved and the Transport
Speed Adjustment screen is displayed.
5
Press the
press the
6
Press the icon.
The Save screen is displayed.
icon on the Service
icon and then
icon.
icon can
by pressing it, and enter
icon.
icon and then
icon.
Information Service Screen
Enter the service passward.
Service Screen
Transport Speed Adjustment Screen
= Make the speed equal to " Low Speed "
on the collator.
= Make the speed equal to "Medium
Speed "on the collator.
= Make the speed equal to "High Speed
"on the collator.
21102
71001A1
21102
71001C1
The speed
can be
increased by
pressing this
icon.
Increase Rate
The increase
7
rate can be set
in the range
from 1 to 10 %.
Initialize the
21102
71001D1
speed settings
for all devices.
21102
71001E1
155