Installing The Fore-Edge Trim Section - Horizon Fitness Bookletmaker SPF-200A Manual

7-2

Installing the Fore-edge Trim Section

1
Connect the wiring between the
fore-edge trim section and the
main part of the SPF.
1. Remove the terminating connector and con-
nector for stand-alone machine from the
SPF main unit.
Attach the removed connector for stand-
alone machine into the socket on the rear of
the fore-edge trim section as shown in the
figure to the right.
2. Connect the wiring as shown in the figure to
the right.
2
Hook the wire from the fore-edge
trim section on the SPF main unit.
3
Place the mounting plate in the
installation position.
4
Connect the fore-edge trim section
to the SPF main unit.
1. Raise the fore-edge trim section locking
lever.
2. Insert the positioning pins for the fore-edge
trim section to the slot on the SPF main unit
to make the connection.
3. Lower the locking lever and fit the locking
pin in the cutout on the lever.
- When the fore-edge trim section is lined up
with the SPF main unit, the locking pin will fit
into the cutout on the lever.
Rear View
11119
70201G1
Connector for Stand-
Alone Machine
Fore-edge Trim Section
Arcnet Communica-
tion Connector
Signal Connec-
tor for Fore-edge
Trim Section
Connector for
Fore-edge Trim
Section
11119
70201B1
þ
Wire
Positioning Pin
Fore-edge Trim Section
Locking Lever
Locking
Pin
Locking Lever
Fore-edge Trim
Section
Overhead View
Lined up
11119
70201A1
SPF
Terminating
Connector
Connector for
Stand-Alone
Machine
Mounting
Plate (Large)
11119
70201C1
SPF
11119
70201D1
141
7