Stitcher Head Removal / Attachment; Stitcher Head Removal; Stitcher Head Attachment - Horizon Fitness Bookletmaker SPF-200A Manual

6-9

Stitcher Head Removal / Attachment

6-9-1 Stitcher Head Removal

1
Turn off the power switch.
2
Cut the wire and stick the end of
wire in the wire coil.
3
Loosen the locking screw for the
T-nut on the stitcher head.
- Loosen with a T-wrench.
4
Slide the stitcher head to the side
and remove it.

6-9-2 Stitcher Head Attachment

1
Turn off the power switch.
2
The stitcher head and former are
marked with dots of the same
color paint.
Each stitcher head and former work together.
Mark the former so that you can attach it to the
correct stitcher head.
3
Attach the accessory detection bar
to the stitcher head.
- Attach the detection bar to the stitcher head
on the operator side only.
- Screw the detection bar into the screw hole
on the block.
- Set the detection bar height at about 82 mm
or 3.23."
4
Attach the stitcher head to the
head slider.
- Press the drive pusher firmly into the drive
beam. If the two parts are not engaged cor-
rectly, the stitcher head may get damaged.
132
T-Nut
11119
60901A1
Detection
Bar
Mounting
Nut
Block
11119
60902C1
Drive
Beam
ãÏìÆÉrÅ[É
Drive
Pusher
11119
60902B1
Head Slider
6-9-1
6-9-2
T-Wrench
11119
40101K1
About 82
mm
11119
60902D1
11119
60902A1