Fore-Edge Trimming-Related Problems; The Sheets Are Trimmed Incorrectly; Incorrect Trim Position - Horizon Fitness Bookletmaker SPF-200A Manual

5-6

5-6-1 The Sheets Are Trimmed Incorrectly

Where to Check
The sheets may
not be straight
when they are to
the fore-edge
trim section.
For small book-
lets (less than
B5) the fore edge
trim section must
be moved for-
ward.
The booklet may
expand by differ-
ent amounts at
the top and bot-
tom.

5-6-2 Incorrect Trim Position

Where to Check
The stitcher may
be set so the
stitcher hits the
booklet stopper.
The booklet may
be hitting the
stopper.
112

Fore-edge Trimming-Related Problems

21102
50501B1
1 1
3
2 2
11119
50601A1
11119
50602C1
160.0
11119
50602A1
21102
50602B1
Cause and Solution
- Select for the fold section jog direction
on the Binding-Status Setting-Fold/Fore-edge
Trim/Conveyor screen.
- The default setting for the fold section top and
bottom guide delivery stroke is 1.0 mm or
0.040."
- When doing fore-edge trimming on small book-
lets (under size B5), the booklets may not be
transported straight because one transport belt
hooks the edge of the booklet.
- Lift the fore-edge trim section locking lever and
move the fore-edge trim section to the front,
then lock it again.
- To prevent the booklet from moving diagonally,
adjust the height of the transport belt on the
front only.
Cause and Solution
- Set the stitch distance within the range shown
below so that the stitcher will not hit the booklet
stopper.
If the top and bottom distance is 185 mm
(7.285") or more
79.1 to 92.0 mm
138.0 to 150.9 mm
234.0 to 246.0 mm
3.860" to 5.905"
If the top and bottom distance is shorter than
185 mm (7.285")
79.1 to 80.9 mm
3.115" to 3.185"
- The booklet may bounce back if it hits the stop-
per. Decrease the gap between the transport
belts to prevent the booklet from bouncing back.
Related
Item
Page 25
3-3-2
4-5
Related
Item
3-2
step 4
4-5