Stitch Section - Horizon Fitness Bookletmaker SPF-200A Manual

1-2 Machine Descriptions

1-2-6 Stitch Section

The operation of the stitcher head is explained in Section 4-1.
Wire Coil
Standard wire is No.25 (0.5 mm in diameter)
Optional wire No.26 (0.45 mm in diameter) is
available.
Coil Brake
This brake prevents the coil from turning too easily and tangling
the wire. If the brake is pressed harder against the coil, it becomes
harder to turn the coil.
There are circuit breakers inside this cover. See Section 6-10.
Stitch Angle Adjusting Knob
The stitch angle can be adjusted using this knob if one
stitch is not lined up.
8
Wire
Guide
Red LED
This lamp lights
when the sensor
detects the wire
guide.
11119
10206A1
Sheet Holder
This holder prevents the sheet from
floating. Long, short, and side stitch-
ing holders are available. Select the
holder to match the binding pattern
and sheet size. To change the holder,
loosen the locking knob. Set the
position of the holder to match
the thickness of the book-
let.
Locking Knob
11119
10206D1
Wire Feeding
Detection Sensor
As the wire is feeding, the
wire guide bends down and
immediately returns to its
original position. This sensor
watches the movement of the
wire guide to see that the
wire is feeding properly. The
sensor is turned on (red LED
lights) when the wire guide is
bent down.
11119
10206C1
Clincher Lever
This allows you to remove a stitch which remains in
the clincher section.
Stitcher Head Drive Block
When one of these blocks is removed, the machine
does not make stitches on that side. The block on
the non-stitched side should be removed when you
are doing corner stitching. (The instruction screen
is displayed on the touch panel.)
These holes allow for
installation of two
optional stitcher heads.
The positions of these
two stitchers are fixed.
11119
10206E1
1-2-6
Stitch Section
11119
10206B1