Horizon Fitness Bookletmaker SPF-200A Manual page 97

5-1 If an Icon Is Displayed on the Error Screen
11119
50101B1
10th set to the last
Last set
If the faulty set ejecting function is turned on and a faulty set is
delivered to the faulty set ejecting tray correctly, the icons indi-
cate the cause of the problem.
If the same error is displayed repeatedly, follow the procedure
listed below to correct the problem.
= A feed error has occurred at the upstream device.
Set up the feed section of the upstream device again.
= Sheets for manual feeding were not loaded in time to
be fed. Load the sheets into the manual feed section
to match the feed timing from the upstream device.
= A jog error has occurred in the fold section.
If the sheets are not arranged correctly in the stitch
section, increase the jogging frequency using the
Binding Status Setting screen. (Refer to
If the problem occurs again, increase the distance
between the fold knife and the jog pusher using the
Binding-Fine Adjust-Fold Section screen. (Refer to
Section 1-3-7.)
= The front wire is not stitched.
= The rear wire is not stitched.
Check if the wire has run out, or if the wire has
jammed.
= A booklet thickness error has been detected in the
fore-edge trim section. Check the booklet. If the prob-
lem occurs again although the booklet thickness is
OK, decrease the sensitivity using the Binding-Status
Setting-Option screen.
5
)
page 25.
89