Folding-Related Problems; Fold Skewing; The Folding Position Varies - Horizon Fitness Bookletmaker SPF-200A Manual

5-5

Folding-Related Problems

5-5-1 Fold Skewing

Where to Check
The sheets are
not straight when
they are trans-
ported to the fold
section.
The stopper in
the fold section
must be adjusted
correctly.
The jog pusher in
the fold section
must fit to the
sheets.
The fold delay
time may be too
short.

5-5-2 The Folding Position Varies

Where to Check
The stitch posi-
tion may be set
so the stitcher
hits the fold knife.
A piece of paper
may be left inside
the guide in the
fold section.
Cause and Solution
- Turn on the stitch section top and bottom guide
delivery stroke using the Binding-Status Setting-
Collator/Faulty Set Detect/Manual Feed/Stitch
screen.
21102
50501A1
- Adjust the stopper angle by turning the fold
screw correction knob.
21102
50401H1
- Adjust the distance between the fold knife and
the jog pusher using the Binding-Fine Adjust-
Fold Section screen so that the jog pusher fits
against the tail edge of the sheets while the
sheets are being jogged.
21102
50501C1
- Increase the fold delay time (press
increase) using the Binding-Status Setting-Fold/
Fore-edge Trim/Conveyor screen.
21102
50501D1
Cause and Solution
- Set the stitch distance within the ranges shown
below so that the stitch will not hit the fold knife.
73.0 to 92.0 mm
138.0 to 162.0 mm
162.4
234.0 to 246.0 mm
3.860" to 5.905"
11119
50502A1
- Press the Emergency Stop button, remove the
fold section cover, and lift the buckle gap adjust-
ing knob to check inside the machine.
11119
50502B1
Related
Item
Page 24
Page 24
3-4-3
to
Page 25
Related
Item
3-2
step 4
5-2
109
5