Horizon Fitness Bookletmaker SPF-200A Manual page 56

3-3 Doing a Changeover
- The screen shown to the right may be displayed
before you begin the changeover for corner stitch-
ing.
- This screen is used to confirm the stitcher head
positions.
This screen is displayed in the situations listed
below because the machine does not know the
current positions of the stitcher heads.
- First changeover since the power was turned on.
- If an Emergency Stop button is pressed during a
changeover.
- Select either icon.
A: The stitcher heads are positioned in the cutout
of the corner stitch guide.
B: The stitcher heads are positioned outside of the
cutout of the corner stitch guide.
If the stitcher heads are positioned in the cutout of
the corner stitch guide, the stitcher heads will
interfere with the guide during the changeover.
This screen appears to prevent a case where the
stitcher heads hit the corner stitch guide.
- After making the right selection, press
48
Stitcher Head Position Confirmation Screen
11119
30301W1
11119
30301X1
.
3-3-1 Removing Parts Before
the Changeover
A B
Corner Stitch Guide
Cutout
11119
30301Y1