Fore-Edge Trim Section - Horizon Fitness Bookletmaker SPF-200A Manual

1-2 Machine Descriptions

1-2-8 Fore-edge Trim Section

Booklet Stopper
This stopper is automatically
set to match the finishing size
of the booklet.
11119
10208A1
Fore-edge Trim Section Locking Lever
If you are trimming small booklets (smaller than B5), the booklet may not move correctly if the pressure is
different at the front and rear transport belts.
Transport Belt
Stopper
Transport Belt
11119
10208C1
When the fore-edge trim mechanism is moved to the front, the stopper holds the far side of the booklet,
and the booklet should stop straight against the stopper.
(The instruction screen for this is displayed on the touch panel when binding sheets smaller than B5.)
10
Transport Belts
The sheet is transported by these belts.
The gap between the upper and lower
belts is automatically set up to match the
book thickness entered on the touch panel.
Lift the locking lever up and
move the fore-edge trim mech-
anism to the front.
Front Transport Belt Height
Adjusting Knob
If the booklets do not move correctly, adjust
this knob. To reduce the gap at the front of the
transport belts, loosen the locking lever and
turn the knob clockwise.
Locking
Lever
Trim Knife (Upper Knife)
Jam Sensor
Infeed Belts
These belts move the sheet into the fore-
edge trim section.
Position for Small Booklet
Normal Position
1-2-8
Fore-edge Trim Section
11119
10208B1