Troubleshooting; If An Icon Is Displayed On The Error Screen; If An Error Icon Is Displayed - Horizon Fitness Bookletmaker SPF-200A Manual

This chapter explains how to correct some typical problems.
5-1

If an Icon Is Displayed on the Error Screen

5-1-1 If An Error Icon Is Displayed

If a problem occurs, a sensor will detect the problem and stop the machine. Icons which indicate the
error status are displayed on the touch panel. This section explains the meaning of the error icons.
4 1 2 1 4
20
5
6
7
19
8
9 2 10 11 2 12
18
11119
50101A1
No Icon
A cover is open.
1
Close the cover and press
Some sheets are jammed.
Open the cover, remove the jammed
sheets, and press
2
If this error occurs even though there is no
130, 151,
jammed sheet, see the error code (page 90)
155, 156
and correct the problem.
There was too much load on the jog section
top and bottom guide, or the transport
3
pusher, and one of the parts moved.
Press
An Emergency Stop button has been
pressed.
4
Turn the Emergency Stop button to release
it, then press

5 Troubleshooting

1 3 2 1
16
21 13 14
15
17
Explanation
.
.
.
.
No Icon
There is a problem with the wire feed. Press
and check if the wire is jamming
inside the stitcher head and is strained.
If the problem occurs again even though the
5
wire is OK, change the wire feeding detec-
tion setting. (Refer to Section 3-5, step 4.)
On the Administrator Mode screen, change
the number of stitches until this error is
detected. (Refer to page 31.)
A faulty set was not delivered to the faulty
set ejecting tray. Icons indicating the prob-
lems are displayed here.
6
Remove any booklet which has been deliv-
ered to the downstream device (delivery
conveyor) and press
The faulty set ejecting tray is full.
Remove the booklets from the tray and
7
press
An error has occurred in a downstream
device.
8
Clear the error in the downstream device,
and press
The trim chute is full.
9
Remove the trim and press
The belt speed for the fore-edge trim unit is
slower than the speed of the upstream
device.
Press
10
Adjust the transport speed for the fore-edge
trim section by pressing
Administrator-Transport Speed Adjustment
screen.
The spacing between the transported booklets was too
short, and the booklets cannot be trimmed correctly.
Press
The booklet delivery from the SPF-200A/200L is incor-
rect. The sheets may not be fed into the fold section
smoothly. Check if there is a piece of paper remained
11
on the sheet path.
If there is no piece of paper remaining, increase the
fold section top and bottom guide stroke using the
Binding-Status Setting-Fold/Fore-edge Trim/Conveyor
screen.
If the problem occurs again, slow down the production
speed.
Explanation
.
.
.
.
.
on the
.
87
5