The Sheets Are Not Stitched; The Wire Jams - Horizon Fitness Bookletmaker SPF-200A Manual

5-3 Stitch-Related Problems

5-3-7 The Sheets Are Not Stitched

Where to Check
The wire feed On/
Off knob may be
set to the Off
position.
The stitcher drive
blocks may be
missing.
The coil brakes
may be too tight.
The wire is tan-
gled, or has run
out.

5-3-8 The Wire Jams

Where to Check
The wire may be
crooked.
The former may
not be installed
correctly.
Cause and Solution
- Turn the wire feed On/Off knob and close the
gap shown by arrow on the illustration to the left.
11119
50307A1
- If the stitcher drive blocks are missing, install
them.
11119
50307B1
- The coils will be difficult to turn, and the wire will
not be fed smoothly if the coil brakes are
pressed against the coils too tightly. Loosen the
coil brakes a little.
11119
50307C1
- Straighten out the wire if it is tangled.
- If the wire is tangled inside the stitcher head,
adjust the angle of the eccentric shaft.
- If the wire has run out, replace the wire coil.
11119
50307D1
Cause and Solution
- If the wire is not straight, it will not go through
the former, causing jams.
- Adjust the angle of the eccentric shaft so that
the wire is fed straight.
11119
50305A1
- Wire may not be fed because it does not go into
the former smoothly. Check that the former is
installed correctly.
11119
50308A1
Related
Item
-
page 47
1-2-6
5
5-3-8
6-1
Related
Item
4-1
-
103