Confirming The Status Settings - Horizon Fitness Bookletmaker SPF-200A Manual

3-5

Confirming the Status Settings

This section only describes the status set-
tings you must make before every binding
operation. There may also be other status set-
tings which are not mentioned here.
1
Display the Binding-Status Setting
screen.
2
Select
is used in the VAC.
The Caution screen is displayed.
- Press to start the changeover.
3
Select
faulty set ejecting function.
4
Select
feeding detect function.
If the wire has almost run out, the sensor may turn
off even though the wire is still feeding correctly. If
this happens, press
5
To do manual feeding or feeding
from the HMU (the manual feed
unit of the optional VAC), select
the proper icon.
= No manual feeding
= Only manual feeding
= When the HMU is used (Hand
Marry Unit of the collator). This
function cannot be selected on the
screen. This function can only
selected using a switch on the
HMU.
= Feeding starts from the collator
after sheets are loaded in the man-
ual feed section. (Production speed:
Slow)
= The sheets are fed manually to
match the feeding from the collator.
(Production speed: Fast)
= The sheets are fed manually under
the sheets fed from the collator.
To do manual feeding, go to Section 3-7.
60
if the support guide
when using the
when using the wire
.
11119
30501A1
Caution Screen
Status Setting-Collator/Faulty Set Detect/Manual
Feed/Stitch Screen
2 2
3 3
4 4
5 5
21102
30501B1
21102
30501C1