Binding-Status Setting Screen - Horizon Fitness Bookletmaker SPF-200A Manual

1-3

1-3-8 Binding-Status Setting Screen

Items marked like this
Transport Speed
This indicates the operating speed of the belt or roller. It
can be adjusted in six steps.
VAC Support Guide
(Used for sheets with a width smaller than 148 mm (5.83").)
= Guide is not used.
= Guide is used. This can be selected when sheet
width is 230 mm (9.05") or smaller.
Faulty Set Ejection
= Faulty Set Ejection Off
= Faulty Set Ejection On (When an error
occurs in the upstream device, booklets are
delivered to the mis-feed tray without trim.)
Wire Feeding Detection
This function is used to watch that the wire is fed correctly.
= Off
= An error is detected if the sensor is activated for a set time.
= An error is detected if the sensor is active or not active for
longer than the specified time.
- Normally use .
- If there is just a small amount of wire left, the sensor may keep deactivating
even though the wire is being fed correctly. If this happens, select
Manual Feed Setting
= No manual feeding
= Only manual feeding
= Using the HMU (Hand Marry Unit on the collator). This function cannot be selected from the screen.It must
be selected by using the switch on the HMU.
= Feeding starts from the collator after sheets are loaded in the manual feed section. (Production speed:
Slow)
= Use when feeding the sheet manually to match the feeding from the collator. (Production speed: Fast)
= Use when feeding the sheet manually under the sheets fed from the collator.
24
Screen Descriptions
are default settings.
Binding-Status Setting Screen
Collator/Faulty Set Detect/Manual
Feed/Stitch Screen
This button is used to match (decrease)
the speed of the trim section with the
stitch section and prevent a booklet from
being pulled while delivery when using
single sheet or performing the job with
folding only.
.
1-3-8
21102
10308A1