Horizon Fitness Bookletmaker SPF-200A Manual page 93

4-5 Fore-edge Trim Section Adjustments
Infeed Belt Pressure Adjustment
- Adjust the pressure of the infeed belts to match the
booklet weight.
- Increase the pressure of the infeed belts if the
booklet stops at the entrance of the fore-edge trim
section.
Infeed Belt Gap Adjustment
- If a small booklet is transported from the upstream
device to the fore-edge trim section at a low speed,
the booklet may stop at the entrance of the fore-
edge trim section.
- In this case, narrow the gap of infeed belt.
How to Adjust
1
Loosen the locking screw as
shown in the illustration to the
right and lower the pulley.
- Adjust both the front and rear pulleys by the
same amounts.
2
Tighten the locking screw.
11119
40501E1
Release
Standard
Strong
11119
40501F1
Stop in this
area
11119
40501I1
Pulley
11119
40501J1
Belt Pres-
sure
Adjusting
Bar
Infeed Belts
4
View from
Rear
11119
40501H1
Locking Screw
85