Horizon Fitness Bookletmaker SPF-200A Manual page 150

7-2
5
Remove the locking parts on the
fore-edge trim section.
6
Attach the leveling bolts.
1. Remove the front cover.
2. 1 long and 2 short leveling bolts are
included. Attach the long one to the side of
the SPF main unit.
7
Place a mounting plate under each
leveling bolt.
8
Turn the three leveling bolts and
lift the fore-edge trim section up to
the correct level.
- Check that all the casters are raised above
the floor. If there is no clearance, raise the
SPF main unit and then raise the fore-edge
trim section.
- After making the adjustment, lock each bolt
using the lock nut.
- If the SPF-200L has a torsion of frame,
make the following adjustments to correct.
(Top View)
Frame of FC
Align here.
Place a mounting plate under either front or rear
leveling bolt. Turn the leveling bolt and lift the SPF-
200L until the torsion is eliminated.
142
Installing the Fore-edge Trim Section
Frame of SPF
These leveling bolts are
attached on the SPF-
200L only.
Locking
parts
Leveling Bolt
(Short)
Mounting
Plate
(Small)
11119
70201E1
Lock Nut
11119
70201F2
11119
70101H1
Leveling Bolt
(Long)
Mounting
Plate
(Large)
Front Cover
11119
70201F1
Match the heights