Horizon Fitness Bookletmaker SPF-200A Manual page 180

8-3
8-3-4 Wire Attachment (continued)
6. Install the relay wire for the sensor.
- Connect the relay wire to the connector (8
pins) on the rear side of the stitcher head
unit.
- Lock the relay wire by using nylon ties
together with other cables.
7. Lock the wire saddle of the relay wire to the
sensor bracket.
8. Connect the cable from the sensor.
9. Install the cable cover.
- Place the excess cable inside of the cable
cover.
4
Adjust the detecting range of for
the sensor.
1. Loosen the lock nut and turn the screw
toward the direction A.
- Check that the sensor is not On when the
wire guide is pushed down and touches the
screw head.
2. Pull the screw to the direction B.
- Pull the screw until the sensor just turns on
when the wire guide is pushed down.
3. Additionally pull the screw with 1/2-turn.
4. Tighten the lock nut.
5
Thread the wire to the stitcher
head.
- Refer to 6-2.
172
Four Stitching Kit FST-200
Cable No. 137
Lock together with
other cables.
Connect the relay
wire with the 8-
pins connector.
Sensor Bracket
Cable Cover
A
B
Screw
Lock Nut
Wire Attachment
Cable No. 136
Pass through this hole
to the opposite side.
11119
80304E1
Cable for
Sensor
Wire Saddle
11119
70301D1
Wire Guide
ON = The lamp lights.
OFF = The lamp lights
out.
11119
80304G1
11119
80304F1
8-3-4