Failed To Fold At Correct Position - Horizon Fitness Bookletmaker SPF-200A Manual

5-5 Folding-Related Problems
5-5-2 The Folding Position Varies (Continued)
Where to Check
The buckle gap
must be set cor-
rectly.
The jog pusher in
the fold section
must fit against to
the sheets.

5-5-3 Failed to Fold at Correct Position

Where to Check
The fold position
must be set cor-
rectly.
The jog pusher in
the fold section
must fit against to
the sheets.
The fold delay
time may be too
short.
The stitcher posi-
tion may be set
so that the
stitcher hits the
fold knife.
110
Cause and Solution
- Uneven folding can occur if the buckle gap is
too wide, or if it is too narrow.
- Set the buckle gap correctly depending to match
the sheet thickness.
11119
50502C1
- Adjust the distance between the fold knife and
the jog pusher using the Binding-Fine Adjust-
Fold Section screen so that the jog pusher fits
against the tail edge of the sheets while the
sheets are being jogged.
21102
50501C1
Cause and Solution
- Adjust the distance between the fold knife and
the stopper using the Binding-Fine Adjust-Fold
Section screen.
21102
50503A1
- Adjust the distance between the fold knife and
the jog pusher using the Binding-Fine Adjust-
Fold Section screen so that the jog pusher fits
against the tail edge of the sheets while the
sheets are being jogged.
21102
50501C1
- Increase the fold delay time (press
increase) using the Binding-Status Setting-Fold/
Fore-edge Trim/Conveyor screen.
21102
50501D1
- Set the stitch distance within the ranges shown
below so that the stitcher will not hit the fold
knife.
73.0 to 92.0 mm
162.4
138.0 to 162.0 mm
234.0 to 246.0 mm
3.860" to 5.905"
11119
50502A1
Related
Item
3-3-3
3-4-3
Related
Item
1-3-7
3-4-3
to
Page 25
3-2
step 4