Installing The Delivery Conveyor; Short Conveyor - Horizon Fitness Bookletmaker SPF-200A Manual

7-4

Installing the Delivery Conveyor

7-4-1 SC-200 Short Conveyor
1
Attach the hanger bolts only if the
delivery conveyor is connected to
the SPF main unit.
- This step is unnecessary for the fore-edge
trim section because the hanger bolts are
already attached.
1. Remove the front and rear covers.
2. Attach the hanger bolts.
3. Attach the removed covers.
2
Install the conveyor.
- To install the conveyor, insert the hanger
bolts into the holes.
3
Attach the supports.
- Use the screws already attached to the con-
veyor and main unit.
- The supports can be attached by just loosing
the screws.
4
Attach the stack plate.
5
Attach the delivery roller.
- Remove the screw on the end of the roller
bar and then attach the delivery roller.
6
Plug in the connector for the con-
veyor.
Side of SPF
Main Unit
Connector
for Delivery
Conveyor
11119
70401G1
Back of Fore-edge
Trim Section
Stack Plate
Support
11119
70401H1
SC-200 Short Conveyor
Nut
11119
70401B1
Hanger Bolt
Delivery Rollers
Roller Bar
11119
70401D1
11119
70401E1
7-4-1
11119
70401A1
7
11119
70401C1
Hanger
Bolt
11119
70401F1
145