Connect The Converter To Profinet; What Do You Have To Set For Communication Via Profinet - Siemens SINAMICS G110M Operating Instructions Manual

Installation
4.4 Connecting the converter to the fieldbus
4.4.2.1

Connect the converter to PROFINET

Procedure
1. Connect the converter to the control via the PROFINET socket X03.
The maximum permitted cable length from the previous station and to the subsequent one
is 100 m.
2. Externally supply the converter with 24 V DC through X01.
You have now connected the converter to the control system via PROFINET DP.
❒
4.4.2.2

What do you have to set for communication via PROFINET?

Configuring PROFINET communication in the I/O controller
You require the appropriate engineering system to configure PROFINET communication in the IO
controller.
If required, load the GSDML file of the converter into the engineering system.
Device name
In addition to the MAC address and IP address, PROFINET also uses the device name to identify
PROFINET devices (Device name). The device name must be unique across the PROFINET
network.
To assign the device name, you need an engineering software, e.g. HW-Config.
The converter saves the device name on the inserted memory card.
IP address
In addition to the device name, PROFINET also uses an IP address.
You have the following options to specify the IP address of the converter:
• You specify the IP address using engineering software, e.g. via HW Config.
• The IO Controller assigns an IP address to the converter.
Telegram
Set the same telegram in the converter as in the IO Controller. Interconnect the telegrams in the
control program of the IO Controller with the signals of your choosing.
90
Connection and cables (Page 67)
Installing GSDML (Page 91)
Drive control via PROFIBUS or PROFINET (Page 182)
Distributed converter for SIMOGEAR geared motors
Operating Instructions, 10/2020, FW V4.7 SP13, A5E31298649B AL