4.3
What do you need for communication via Ethernet/IP?
Check the communication settings using the following questions. If you answer "Yes" to the
questions, you have correctly set the communication settings and can control the inverter via
the fieldbus.
● Is the inverter correctly connected to the EtherNet/IP?
● Is the EDS file installed in your control system?
● Have the bus interface and IP address been correctly set?
● Have the signals that the inverter and the control system exchange been correctly
interconnected?
Fieldbuses
Function Manual, 04/2018, FW V4.7 SP10, A5E34229197B AE
4.3 What do you need for communication via Ethernet/IP?
Communication via EtherNet/IP
85