Configuring Lacp - Lenovo RackSwitch G8264 Application Manual

Configuring LACP

1. Configure port parameters. All ports that participate in the LACP LAG must have
2. Select the port range and define the admin key. Only ports with the same admin
3. Set the LACP mode.
4. Optionally allow member ports to individually participate in normal data traffic if
5. Set the link aggregation as static, by associating it with LAG ID 65:
184
G8264 Application Guide for ENOS 8.4
Use the following procedure to configure LACP for ports 7, 8, 9 and 10 to
participate in link aggregation.
the same settings, including VLAN membership.
key can form an LACP LAG.
RS G8264(config)# interface port 7­10
RS G8264(config­if)# lacp key 100
RS G8264(config­if)# lacp mode active
no LACPDUs are received.
RS G8264(config­if)# no lacp suspend­individual
RS G8264(config­if)# exit
RS G8264(config)# portchannel 65 lacp key 100