Static Flows - Lenovo RackSwitch G8264 Application Manual

Static Flows

268
G8264 Application Guide for ENOS 8.4
You can configure static flow entries for OpenFlow instances. The switch forwards
traffic based on these entries even if it is not connected to a controller. Up to 750
static ACL entries across all instances can be configured. An OpenFlow controller
cannot modify or delete these entries. Static flow entries can replace entries
installed by a controller. Static flow entries are not lost when the switch is reloaded.
Static flow entries are based on the following qualifiers, actions, and options:
Table 22.
Static Flow Entry Qualifiers in OpenFlow 1.0
Qualifier
ingress‐port
src‐mac
dst‐mac
vlan‐id
vlan‐priority
src‐ip
dst‐ip
src‐port
dst‐port
ether‐type
protocol
tos
type
all
Table 23.
Static Flow Entry Qualifiers in OpenFlow 1.3
Qualifier
in‐port
in‐portchannel
in‐phy‐port
eth‐src
eth‐dst
Description
port of the instance
source MAC address
destination MAC address
(0‐4095 + 65535 (untagged))
VLAN identifier
802.1p(0‐7)
source IP address
destination IP address
Layer 4 source port (0‐65535)
Layer 4 destination port (0‐65535)
ʺarpʺ/ʺ0806ʺ or ʺipʺ/ʺ0800ʺ or (hex‐value < =
65535)
ʺtcpʺ or ʺudpʺ or 0‐255
IP TOS (0‐255)
ʺrequestʺ or ʺreplyʺ (can be set only if ether type
is ARP)
all qualifiers or any qualifier
Description
switch input port
switch input static LAG (portchannel) or static
LACP LAG
switch physical input port, valid only when
in‐port is specified
source MAC address and mask
destination MAC address and mask