Lenovo RackSwitch G8264 Application Manual page 506

6. Configure IGMP Snooping.
Switch C Configuration
1. Configure VLANs and tagging.
2. Configure an IP interface with IPv4 address, and assign a VLAN.
3. Configure STP. Reset the ports to make the edge configuration operational.
4. Configure an LACP dynamic LAG (portchannel).
5. Configure a static LAG (portchannel).
506
G8264 Application Guide for ENOS 8.4
RS G8264(config)# ip igmp enable
RS G8264(config)# ip igmp snoop vlan 2,3
RS G8264(config)# ip igmp snoop source­ip 10.10.10.2
RS G8264(config)# ip igmp snoop igmpv3 enable
RS G8264(config)# ip igmp snoop igmpv3 sources 64
RS G8264(config)# ip igmp snoop enable
RS G8264(config)# vlan 2
RS G8264(config­vlan)# no flood
RS G8264(config­vlan)# exit
RS G8264(config)# vlan 3
RS G8264(config­vlan)# no flood
RS G8264(config­vlan)# exit
RS G8264(config)# vlan 2,3
RS G8264(config­vlan)# interface port 1­4,6
RS G8264(config­if)# switchport mode trunk
RS G8264(config­if)# switchport trunk allowed vlan 2,3
RS G8264(config­if)# exit
RS G8264(config)# interface port 5
RS G8264(config­if)# switchport access vlan 3
RS G8264(config)# interface ip 1
RS G8264(config­ip­if)# ip address 10.10.10.3 enable
RS G8264(config­ip­if)# vlan 2
RS G8264(config­ip­if)# exit
RS G8264(config)# interface port 5,6
RS G8264(config­if)# spanning­tree portfast
RS G8264(config­if)# shutdown
RS G8264(config­if)# no shutdown
RS G8264(config­if)# exit
RS G8264(config)# interface port 1,2
RS G8264(config­if)# lacp key 400
RS G8264(config­if)# lacp mode active
RS G8264(config­if)# exit
RS G8264(config)# portchannel 1 port 3,4 enable